Top: Constructed of 18 gauge, type 304 stainless steel die stamped with a raised perimeter bead. The top is solid, full-length, to support the refrigerated display case. There shall be a solid vinyl gasket under the beaded edge to form a seal to the counter top, thus preventing seepage or marring of the counter top.
Display Case: Double wall constructed of type 304 stainless steel – 20 gauge, both interior and exterior, and filled with 2″ of foamed-in-place polyurethane insulation. Customer’s side and operator’s side are provided with a set of two (2) sliding, self-closing, thermo-pane insulated glass doors. The doors are removable for ease of cleaning. The display case is provided with two (2) plastic coated wire shelves, adjustable on 1″ increments and two (2) sets of fluorescent light fixtures mounted behind plastic guards, which are recessed into the side panels. The light fixtures are provided with a separate on/off switch. An internal thermometer is provided.
Refrigeration System: The compressor housing shall be fabricated from 14 gauge galvanized and bolted to the base of the unit. A fully self-contained condensing unit is provided with a hermetically sealed compressor and a thermostat control. The system is also provided with a forced air evaporator for even temperature throughout the display case, and drains into a condensate evaporator pre-wired in the unit. The system is fully charged with CFC-free refrigerant and ready to operate.
Note: Proper ventilation must be provided in counter.
Electrical: The unit will be wired for 15 amp, 120 volt, single phase operation with an on/off thermostat switch and pilot light. A 6′-long, 3-wire cord and plug (NEMA 5-15P) will be provided.
